Separate names with a comma.
Some features disabled for guests. Register Today.
Found the issue: I should have printed 6x of "EMT_18mmVertex_DoveTailBrackets_Rev2.stl" instead of all "EMT_18mmVertex_DoveTailBrackets_Rev2.stl"...
Ok, time for an short update after a brief (ha!) hiatus: For various reasons (probably related to needing table space, needing some extra parts,...
Thanks a lot, I'll give those a go in the coming days. A general question on your .scad files if you have a moment: What is your workflow to...
I've got some shorter screws, those are just what was handy. My concern on the bottom of the vertex is that with no way to retain the nuts and no...
Got the braces printed out this weekend and they look good. The existing STL didn't fit on my print bed so I made my own .stl from the .scad with...
Ok, I think I've got this new filament sorted out. The Rev30 test piece is a good fit now (and rev31 too tight) so I think I'm ready to move...
I think we are on the same page. When I say 1mm, I mean there is 1mm gap between the mating faces when pulled in the X direction (not that there...
Question about this bit: geodave810/Emmett-Delta I printed this piece previously and it was a very tight fit but I think that was mostly due to...
Quick update: Got a Pi 3 coming in the mail so I can try Klipper. Cut my horizontals to 'size' (there is some variation). Printed the 'test-fit'...
If klipper supports Delta kinematics I'll give it a shot. I mocked up the linear motion on one of the towers to get an idea of how I want to...
I pulled at the pipes with my fingers and can't get much deflection. deflection goes up as the square of the length, If I start having trouble I...
Cut and partially assembled my towers. Fit ended up being a bit tight, but some trimming and gentle persuasion seem to have done the trick. Need...
I think they were just under 3 hours each but my print settings are somewhat aggressive: .3mm layers, .6mm extrusion widths and 80mm/sec print...
Tests with the clips was promising so I went ahead and printed the lower vertexes. Do I understand correctly that the design is now intended for...
So put three holders at both ends+middle of a side-span to assess rigidity, is that right? Sounds easy enough. It's looking like I'll be going...
David, Thanks for all the work you have put into this design! I've read through the Cobalt Griffon's build log, printed a few test pieces to...
