Separate names with a comma.
Some features disabled for guests. Register Today.
No, that is the correct sequence. Homing sets a reference point in the machine co-ordinate system. Combined with the max dimensions settings in...
Have you considered moving the camera instead of the table? At that size it might mean moving less mass. Alex.
I'm not a frequent Openbuilds Control user, but if you go to grbl settings there should be an option to reverse the direction of any axis. The...
As @David the swarfer said plus, if you are setting XYZ zero immediately after homing that is not necessary. Homing sets your machine coordinates...
English only please. Translation;- "I want to buy the openbuilds 1515. I'm going to add a 110v 2.2kw hy huanyang spindle. How would I install a...
Yes, my bad Peter - have deleted the erroneous post. Alex.
As above, especially as I note you replaced the usb cable - might the quality/length of the replacement be a factor? Alex.
You can use the Lead 1510 profile as a starting point, and then tweak settings as @David the swarfer said above. You might also have to adjust...
Yes, a workbee is capable of cutting 3/4" aluminium, but you do need to take into account that the bit is going to be sticking out at least a...
These are your Z commands - none of the commands in your g-code file go any lower than this, and your Z safe move is only to Z0 - presumably to...
What cam software are you using? Do post your g-code file so we can look at it. Also, what controller are you using? - if a grbl one post your...
G-code seems OK, so machine doesn't do what you told it to. Can you jog below Z0? Alex.
Yes, that's how it works - once you set a workplace coordinate system zero the controller remembers where that is relative to the home position....
Dry PTFE or Silicone spray is the lubricant to use on leadscrews. You don't need to use a lot. Also check that you have good connections on your...
All good except for the one in the quote above - that is perfectly correct for most cnc controllers but won't work with the Duet controller and...
Yes, I can, but it's bedtime here in the UK and I'm busy tomorrow. To answer the first question I need to know what version of Ooznest's firmware...
On my phone, so didn't look at the videos yet, but your description sounds very much like a loose/intermittent connection on one wire out of the...
As this is not an Openbuilds machine you will have to give us a bit more info. My research suggests this is from Makerstore and could be either...
I am also not familiar with a V3 workbee - neither Openbuilds nor Ooznest ever sold a V3. I do have the drawings for all the original workbee...
The post processor creates a g-code file from your toolpaths that is compatible with the BlackBox controller. It is not a Vcarve file. To save a...
