Separate names with a comma.
Some features disabled for guests. Register Today.
Okay, ill try, thanks
I have tried that, uninstalled it then redownloaded and installed. A week later the old version came back to haunt me.
My OB controller software reverts to the older version and wants to update about every other time i use it. I would just disable updates, but i...
True, ive never tried selling anytbing, just a hobby
Im disabled on a fixed income, $40 is a lot. lol
Lightburn free?
I tried this last week, Uninstalled both. Redownloaded latest from the site. Computer restarted todat and reverted to an old version again. :(
I just added a generic diode laser to my lead1010 xproV3 Tried to run Laser GRBL and it kind of worked, BUT....LaserGRBL did not have a Z control...
Thanks, ill check that tomorrow
OB control always opens to an older version that doesnt allow continuous jog. Then about the time i have is all set to run it updates to the newer...
Thanks, but how do i get laser on off control through software? Will watch that vid when i get a chance
I am adding a "30w" diode laser to my lead1010 with xpro V3, where/how should i connect the 3 wires? Power,gnd,ttl TIA
I think V4, thank you!!
Thanks Can you direct me to a pinout of that MB that shows which connections im looking for
I have the MB that came with the Lead1010 at launch, not sure ahat it was called Can anyone point me to instructions on how i would wire up a...
Will that probe system hook up and work with the older original Lead 1010 control board it came with at release?
What about the DRO precision, even if i had the probe, if it only recognizes .010" thats not good
In Openbuilds control is it possible to change the Jog increments? I work in inch, and the minimum increment is .010, that is too much when...
Around 035"
I will check on that, thanks! So reading between the lines it sounds like youre saying i will have to take the machine apart to adjust those? Lol...
