Separate names with a comma.
Some features disabled for guests. Register Today.
well I'm almost there. As i said before my machine was out of service for a couple of weeks. so just getting back to it. Thanks for your...
Ok my apologies. It does work. I’m not not sure what I was thinking. Hit the top of stock perfectly. Not enough coffee I guess. Keep up the good...
Maybe. Having said all that I think I just realized that I was doing this without an actual piece of stock. Give me a few minutes and I’ll get...
Hi misterg, I just tried your new version and the only comment I have is. It always resets back to z0. If I had previously set z0 to top of stock....
So part of my consistency problem was the acme nut is worn out on my Zscrew. I had about 3 mm play along the z. I have it torn apart and waiting...
I did as you suggested and reset G30 higher than it was. I had come to the same conclusion after the errors using the macro. As for my earlier...
Hey Misterg, I was testing this again after setting the macro to run on startup which it did fine. homed the machine, ran the macro from the...
I just put a physical button on the end of my machine to turn the leds on and off on demand. wired it to the main power adapter cuz my leds are...
As per Peters post above the link to function JobNeedsHoming is already built in to the control software. so couldn't you just call it before...
Well most of the issue was that i didn't home it before I ran it. so that was very important, could the program check first and offer that? it was...
I have just tested this on a BobsCNC EVO4 and it took a bit to figure it out, i didn’t have a previous code loaded. So i moved the machine to a...
