Separate names with a comma.
Some features disabled for guests. Register Today.
This is the shim packet I bought Steel Shim Assortment 150Mm X 150Mm (4 Sizes) | Assortments - Shim Stock I mainly used the two smaller sizes I...
I aligned a top linear rail on one side to a set distance between the top of the side C beam and the side of the linear rail and tighten the...
I’m on a tour at the moment.. I should be able to reply with a detailed answer tomorrow.
Here's some links to the tension nuts and bearings I used. I'm in Australia so the shop may not be relevant to you Thrust Bearing set Thrust...
Edited to give correct dimensions Re tension nuts and thrust bearings - you need a set at each end of the lead screw. The go on the outside of...
I thought about that but I’d want 8 or 10mm side plates rather than the 6.4mm. I got a quote to water jet cut a set of 8mm plates before I bought...
I’ve been using mine for almost 12 months now. I went with a Makita RTO700 as a spindle as I had one already. I’ve added a few more things since...
No, 532mm would be fine. If your blocks are 16mm then 532mm is the measurement to go for. I mounted the side plates to the linear blocks, square...
I've been threatening to get/build a CNC for years but I wanted one to fit a small existing space (810mm x 810mm) so I had to build my own. After...
Lappa published a new build: A Sphinx Linear rail build (600mm x 600mm) hence the title Sphinx66. Plates supplied by Chris Laidlaw. Linear rails...
Just an update. The Serial.print((char) 0x18); worked great. Problem solved. Thanks for your help.
Thanks for the reply. Homing works fine even with my offline controller set-up. I have a button press routine to clear the limit switch after it...
Thanks for the the ctrl-x format. I wasn’t using that exact format. I’ll try tomorrow and see if that works. The reason I have to jog out a couple...
All switch lines filtered with op amp circuitry. System works no problems with UGS, Candle, Lasergrbl. As I said in my original post it’s not a...
I am building an offline controller for a generic 3018, using a nano and interfacing into the 8 pin connector on the control board. All works as...
