Separate names with a comma.
Some features disabled for guests. Register Today.
Hey Kaegan - once you have connected to your machine go to the troubleshooting screen and manually activate the switch you have issues with....
Got it - busy is good Thanks for the reply
Any update on this file issue? Thanks!
Just updated Light and Dark mode looks great Did notice the " Open GCODE from File" does not return to current folder ? Curious if others have...
like the design - nice job
Okay - found the "limit switch installed" switch off Strange - suspect operator error!! Thanks again!
Gary, Found the issue loose "yellow" wire at Blackbox connection point "Abort" is still active not sure about this - "Home Al"l is not active...
Hey folks, I was in the middle of a cut yesterday and my X axis made a terrible sound. I reloaded the control software this morning but no good....
Hi Frank, I think you will like the Workbee 1010, I think following the videos seemed to work for me, had to repeat some of them to make sure...
So it begins built my table to support the Workbee 1010, organizing the parts. I like the way items are packaged. okay made great progress with...
everything came up nice this morning no growl hope to cut later today
okay Checked wire harness no issues Checked switch open and closed no change Removed x limit and put in place of y limit status light went to off,...
Peter, thanks for the info, I'll be working on the build today and looking at the switch and wiring is on my list! I agree support has been very...
I will try that tomorrow, it acts like a nc contact. Suspect a bad switch Thanks for your input
Hello just starting my workbee 1010 everything looks good however the status light on Y limit is on(red), when all others are off (green) "home...
PaulN published a new build: Hey all looking forward to sharing this build, I’ve learned a lot reviewing many of these great builds. Read more...
