Separate names with a comma.
Some features disabled for guests. Register Today.
Problem solved. Now for my purposes, I always want the centre of whatever bit I am using to be at the bottom/left corner of the work which is why...
Correct diameter entered, correct probe type selected, machine calibrated. If I remember correctly, the probe is supposed to probe inside the...
When setting up the openbuilds probe I use a brass 6.35 mm rod. After running the probe app and then moving the bit to the X,Y,Z=0 position the...
Does anyone have the GRBL settings for the new Sculpfun SF-S9 40W laser assembly?
I just received the standalone subject laser which will work out of the box. However, I want to use the laser head in my openbuild machine and...
If I may impose on you for some additional advice. I have attached a few photos of my home-built machine which is approximately 5'x10' and is...
I was trying out a project that had some hole drilling in 1/2 in baltic birch. The first hole would drill just fine, but the second and subsequent...
I have the parts from a Ready2Rout lift and fence (terrible machine - don't buy) that bit the dust because of poor design and electronics. I have...
That did the trick. However, I have some openbuild limit switches that I could rewire and place in parallel for all axis, instead of proximity...
I am using the X32. I upgraded the firmware. Then I re-ran the probe cycle after re-homing my machine. This time the bit moved to the center of...
I have the probe setup and in running the troubleshooter it indicates that it is working. However, when I try to initiate a probe nothing happens...
You are correct - my bad Rick
My current limits for $130-$132 are 100, 1000, 1000 respectively (what are the dimensions: mm, in, ?) . For example: G91 G0 Xnnn – where nnn is...
z_limit switch fixed - some close tolerances with my other parts which was interfering with the z-axis movement.
Z-limit switch is ok.
I had the homing cycle working yesterday after I calibrated the steps/mm on all axis. Today, I can't seem to get homing working properly. The...
Thanks Shawn, Next issue is my homing. I have a long Z- Axis and while homing the z-axis stops after a certain distance and I have to redo the...
My Y-axis is rack and pinion driven. I need to establish the steps/mm. Can someone point me to a tutorial or explain the process.
Thanks Garry, I have fixed all the wiring problems and now have a smooth running machine in all three directions. As noted before, I have...
I swaped the wires around and both Y-axis motors are moving in the same direction. However, when I powered on the system the current warning...
