Separate names with a comma.
Some features disabled for guests. Register Today.
I have set my machine using size and calbribration modified Lead 1010 settings. The X,Y, and Z go in the proper direction. This required $3 to...
I have followed your instructions and I made sure that the GRBL setting are correct. I also worked on the limit switches so that the machine will...
The machine is a Ultimate Bee, 750x750, x cutting = 523, y 512, z 180. I have the OB electronic set up with hi torque motors and OB limit...
I have followed the interface setup instructions line by line. It indicates that the firmware is up to date and that it is connected to my Wifi....
I do not think that I have homed the machine properly. Are there instructions on how to do that. I have tried to figure out what the GRBL...
I am trying to set up my Ball screw CNC with the OB electronic package. I have been unable to get the XYZ probe to work. When using Open Build...
From lt to right above the current adjusters for each axis. c) Status LEDs Door LED: On when the Door input signal is active Tool On: Indicates...
The Millright has ballscrews and linear bearings. I don’t know of an OpenBuild machine that’s has both of those. If you want to make a machine...
If I actually complete a working machine, I now know what my 1st aluminum project will be. That is a great looking z.
I am going to try a 600x600 build. Would 640mm lead screw’s be long enough? Also, if I were to use Chris’s 11inch plates, do the z pieces need to...
Thanks Rick. What would be the cutting size for a 1075 and which axis is best to shorten? Ray
I am sure that this is covered somewhere but.. I have limited space and would want to make a 1010 LEAD in to a 1075. How hard is this to do and...
