Separate names with a comma.
Some features disabled for guests. Register Today.
I'll dig into it & figure out what's happening. I just wanted to check first & see if there was anything different about BBx32, since it's the...
& just a week ago the wireless relay magically remembered to stay on when the power was off. Thanks for the insight.
I recently replaced my original Blackbox with a Blackbox X32. I previously used the 'with door' firmware, and I flashed the 'with door' firmware...
My Blackbox (original) died - a sudden disconnect and a slight smell of burnt electronics. It's worked reliably for years, & it was just time to...
Tested, working, thank you!
I cut sheet acrylic & zero to the spoilboard. Occasionally I won't get a cut fully through the material & I need to adjust Z0 slightly. To do so,...
On my [SPAM] Bee, I use a Huanyang HY series Inverter and a 110V 1.5KW water cooled spindle. They've worked flawlessly for the time I've owned...
I've used acrylic or polycarbonate under my drag knife. Lexan (polycarbonate) can be bought in pieces at the big box home improvement stores.
three macros: **Goto Probe Z0 & Change** G90 G21 G17; set modes G53 G0 Z-18; move Z up G53 G0 X-206.2 Y-622.6; move to back right corner **Goto...
I just restarted CONTROL. Homed, then jogged around without issue. Flipped to the Macros tab & jogged around more without issue. Then I ran my...
FYI - I haven't done anything with my computer yet... I'm kind of feeling like it's not the computer, so I'm going to keep using it as-is & see if...
I do too and agree. We use Trend Micro at work & after installation it noticeably slows everything down. But it's policy, so we all get it. The...
Okay - I wanted to rule that out before I address this. I'm running a ~10 year old HP Z420 Workstation. Processor: Intel(R) Xeon(R) CPU @...
What are the minimum hardware requirements for CONTROL v1.0.333 & up? Apologies if this is posted somewhere & I missed it... I looked.
Listen to this: Spindle Squealing on Vimeo This is my water cooled 1.5KW, 110V spindle. It's cutting air over a jig. The same short program, run...
Yes, it helps. Thanks!
I'm running my new machine with my water cooled 1.5kw spindle & Huanyang VFD. Setting PD014 is acceleration & I'm currently at 8 seconds. I'd...
PD70 was it! Thank you!
My motor is 2 pole - I checked PD143 and it was set to 4. I changed it to 2 and... no difference. I decided to start fresh; reset everything w/...
I'm setting up a 1.5kW, 110V, 24000RPM spindle and the HY01D511B VFD Controller. I followed the directions & settings in Josh's thread - the only...
