Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks.
Good morning So I have installed all the limit switches on all the axis. $21 is enabled. No joy. Nou I do not have any movement as the hard limit...
Ok thanks for the advise. I will try doing this through the week.
The machine run 100% without limits. Are you saying that I need to install all the limits first before it will work correctly?
That is my plan eventually but for now I just want my hard limits to do their job.
Hi all. I started working on my machine again. I have installed the limit switches on my y axis first. I then tested it. It works well in stopping...
O by the way. With which control board will they work?
Ok thanks. Now I know which limit switches to use.
Not triggered 4.3 Triggred 4.7
I did an of machine test. I connected the blue wire to ground and the brown to positive on my 24v power supply. I connected the black wire to pin...
I tried connecting them directly. When I enable $21 after connecting them that is when the alarm message appears.
Proximity sensor, M12, 6-36V, NPN, Normally Open
Thanks for the reply Peter. I bought the NPN sensors to do my limits but it seems now that I must accept that I am not going to use them and write...
Hi Guys. I want to use my proximity sensors and have read that I will need to use 10Kohm pull up resistors. Where do I install them?
Ok so I got the micro switches to work. I still have no joy with the proximity sensors.
Which wiring? The control box with the drivers and control board?
Hi Peter You gave me a mouth full to think about. What I can tel you is that my uno r3 is original. I believe that I wired it correctly. There is...
Hi Alex. I connected the switches as normally open as the proximity sensors were that. I will try $5 =1 and will get back to you.
Just a status update. I have connected a micro switch to the x axis. Cncjs showed the same message as described in my original post. I do not...
I do have some micro switches somewhere. I will try them and see if it solve my problem.
