Separate names with a comma.
Some features disabled for guests. Register Today.
Im trying to build a low cost CoreXY diode laser using a MKS Gen L V1.0 controller (ATMEGA2560). I was able to flash GRBL onto the controller and...
I'm already using Fusion for CAD and I've got a bit of past experience with CAM so it Fusion look too bad to learn. I'm using a blackbox to...
It never even occurred to me that there might be firmware changes needed for the door switch configuration. I'll take a look at that tomorrow and...
I've wired an e-stop switch into mine as a temp setup to pause the motion as needed. It seems to work intermittently. Pressing the button stops...
Ive recently got the X and Y axis of my router build hooked up to my BlackBox and I am controlling it using Openbuilds Control software. I seem to...
I'll definitely consider reprinting as soon as I get some time. I have some PETG that I havent played around with in quite some time. I doubt...
I just got my X and Y axes moving and I noticed the motors were getting fairly warm after 5-10 minutes of being powered on. I don't think its hot...
It moves smoothly in the one direction. I dont have limit switches installed yet and it looks like they are turned off in the software too. I...
Is there anything I should check to see what would be causing my Y1 and Y2 to only drive one direction? The same motor works fine with x or z so I...
