Separate names with a comma.
Some features disabled for guests. Register Today.
Thank you
Thanks, yes I agree that is the right way to do it, gotta figure out how to do that when I am back at the machine on monday.
Thank you Evan. The acceleration values can be seen on the latest video, they are 100mm/sec2 for all axis. I haven't had a problem with other axis...
Thanks Christian, I slacked all of the V wheels and moved it by hand, seemed to move okay. But then it started stalling again, and it feels like...
I now started installing the beefier motors and tested how the y-axis turna by hand. It turns quite well but I still keep wondering where this...
Thanks Peter. I sent a message to the seller if I could get the electrical specs of them. But I started wondering whether this problem could have...
Thanks Peter. I didn't adjust the acceleration, that remained the same value it was when I first adjusted the nut blocks at 1000mm/min max speed,...
Ok, took a while, but I went through the wiring and then reinstalled everything. Then I proceeded to align the y-axes again and started jogging...
Thank you Peter. I do recall measuring them when installing, but I will do that over again next week when I have a moment. I'll report back then....
Hi all, I built this Workbee a couple of years ago, and never got it fully working, so it was collecting dust for a long while, now recently have...
Many thanks for your help, Peter!
Thanks Peter, that sounds like solid advice. However, as I am in Europe, the shipping would cost couple of times the price of the parts. :(...
[ATTACH] Thanks, Peter. They are these simple&cheap microswitches.
Just remembered to add that I am using an openbuilds blackbox and openbuilds control.
Hi, I cant figure this out; I have the limit switches on all axes, and the hard limits enabled. I have tried adjusting the pull-off distance up...
Thanks once again, Alex, that was it. Now I have been able to calibrate the axes too, just need to tidy up the cabling a bit and find a place for...
I found a loose cable on the z servo, i will test in a moment but I am quite sure that was the reason for weird z behavior.
Thanks Alex. I checked the cabling, and thought of something else; the Y axes being misaligned. I measured and there was 1mm difference between...
Thanks Alex, I will try disconnecting the couplings tomorrow, and if they both move equally easily, I will just try to switch the wires around to...
Hi, I just got my workbee with blackbox and nema23's to the point I could test jogging. After some initial troubleshooting, I can get other axes...
