Separate names with a comma.
Some features disabled for guests. Register Today.
Still too heavy for this machine, but ugs did perform. Thanks again for helping me get this sorted. I never even considered the computer being a...
It's an old laptop. I have some desktops sitting around, will look into them.
So, it turns out the open builds software is no good on that computer. Will try to figure out why picsender doesn't see the blackbox or experiment...
I can't get picsender to connect this controller. Will try ugs when I get home from work, thanks.
Right! So what could be faulty? Should they run identically with the same/ very similar parameters? While I agree, my files could definitely be...
I think there's some confusion here. Quite simply, why does a setup that has significantly more potential hang up on something a shapeoko did...
I will say, it was nice to see accel at 5000 with no stalling and that definitely gives me hope. I've already ordered a bigger machine and was...
Even at 5000 still barely moving, while I can understand my code is not ideal. Looking through various files of over the past year, I see the same...
After looking more closely, the majority of my gcode has been using g1s, the question still remains why the differencein performance? After...
T1 G17 G21 G90 G0Z20.3200 G0X0.0000Y0.0000S12000M3 G0X486.7747Y136.1393Z5.0800 G1Z-4.7650F762.0 G1X486.3649Y136.1356F2667.0 G1X485.9547Y136.1242...
[00:33:03] [ $$ ] $0=10 ;Step pulse time, microseconds [00:33:03] [ $$ ] $1=255 ;Step idle delay, milliseconds [00:33:03] [ $$ ] $2=4 ;Step pulse...
Hi, I recently setup a Black box to replace my carbide motion board. The installation was straightforward and I'm very satisfied with the new z...
