Separate names with a comma.
Some features disabled for guests. Register Today.
Currently running both 1.5.06 in Lightburn and 1.0.374 in control. I will swap boxes back again and see if everything lines up to what you screen...
Went through those things with no luck. I took a chance and swapped my blackboxes on my machines putting the older x4 on the laser and moved the...
Here are screen shots from both. The machine will not move at all in Lightburn. The program acts as if it is waiting for a movement to complete...
Back in Openbuilds Control everything runs and homes as it should. $4 is set to 0. I am grabbing a couple screen shots to show what I see. Maybe...
Hello group..... Im sure someone has come across this and I am just not finding it in the forum. Just finished building an Acro1015 machine with...
Was skimming through the different forums trying to see if this has been brought up for the 1515 but did not come across anything. Is there an...
Just wanted to see if anyone else out there has come across this issue. A few weeks back I replaced all 3 screws on my machine when after review...
Very curious with this idea as I have been approached to carve some short boards. With this model would there be a way to set up to make sure the...
I just went through everything. I reset all settings on CONTROL. Did a new calibration of steps after adjusting tension on the screws. Have a new...
I went ahead and rewired the X Axis and ran a test. The motor sounded fine, did not get any lock ups however still got the same result as far as...
I also see where I can reset EEPROM. Should I look into just doing a full reset on that this evening once I am back to the shop?
Even though there is no stall on the speed up of motor, would a break still cause it to lock up its movement when traveling at full speed? When it...
GRBL Settings $132=90.000 $131=1270.000 $130=1180.000 $122=350.000 $121=350.000 $120=350.000 $112=1000.000 $111=3500.000 $110=3500.000...
With motor on its own the motor does not stall as it speeds up. The motor is at speed when the locking happens. My motors are the Openbuilds...
Unhooked the motor, was able to move the gantry across the machine completely by hand with no binding rail to rail.
It does not go into a higher pitch. It locks up hard as if it was running into a rail or something that would stop its progress.
In the last couple carves I have had an issue with my X Axis where the carve is running fine, then out of nowhere the motor is locking up as if it...
