Separate names with a comma.
Some features disabled for guests. Register Today.
So I discovered that the Y2 motors timing pulley was loose after taking the machine apart, it was loose enough that I was able to pull it off by...
[ATTACH] So I tried using a roughing pass then cutting it to the final dimension as suggested and got this, it's one of the better results but...
I managed to move the machine onto the floor with some help and got all corners of the machine square. After that, it was time to cut the same...
[ATTACH] I was able to fix the problems with getting inaccurate cuts by using the calibration wizard on, at least with the square on the left....
[ATTACH] [ATTACH] Decided to make new test cuts with the recommendations you all gave me. Everything was measured in inches with calipers...
I had a problem with backlash before which was the result of the pulleys on the stepper motors being loose. I used loctite on all the grub screws...
Went to check if the machine was out of square and it was by1/8 of an inch, took me a while to get it all square. After that I ran the same test I...
I've been struggling to get precise cuts on my workbee. Cutting symmetrical things is proving to be more of a challenge than I thought (Example...
I wanted to cut some circles in plywood for one of my projects but I can get a good cut, it happens to be the first cut I made on my Workbee, I...
Ok I seem to got it working, the problem was that it the Workbee settings weren’t being saved. There goes my 80%, anyways thanks for helping a...
I just finished building a Workbee 1510 (my first CNC) but when I tried running a job (hello world) the x and y-axis crash into the sides without...
