Separate names with a comma.
Some features disabled for guests. Register Today.
Ive noticed the machine wobbles from corner to corner as the table underneath that the machine sits on was not flat. The mdf sheet slagged...
Will get them for you tomorrow morning thank you. I meant the belt slipped 3 times out of the pulley and out of the small black wheel into the C Beam
yes I added the cable ties it's a 1510 workbee what could be the reason of the y axis belts slipping out of the pulley ?
I had found things loose and re tightened everything, I still got around 1mm of cutting defect. Could not find anything else loose. If I could get...
Yes i believe i tightened as much as i could, I even added longer bolts and a lock nut to be able to tighten it easier as the current system with...
No luck, slight improvement but still getting a mm or two on certains pocket paths off. Tightened everything. :( Could it be the fact that it is a...
went and got lock right will let you guys know tomorrow when I take the machine apart to tighten everything
Wouldn't the backlash be random if that was the case? I ran the cut twice from same zero position and it cut in the same position over again.
What could be the cause of this it was supposed to pocket 9mm inside the letters, some parts of the letters came less while the other parts came...
I think I may have found the problem the v slots got some acrylic bits in them which is causing the wheels to get harder on some places which may...
ratrig
Had checked the wires they where all tight, How much should I turn the current dial to avoid overheating the motors? Theyr currently at around 50%
I don't think its the shafts, I tried holding the axis on with my hand while jogging it on the PC, i can't seem to see the shaft moving, it more...
Hi guys I am trying to cut out a small sign in 5mm acrylic using a workbee 1510 with Nema 23 Stepper Motor - 1.8degree/step, 175oz-in Problem im...
sorry forgot to attach the diagram
I found the wiring diagram for the motors I was sent from what I can understand is the color codes are not the same for each coil pair as open...
il have a look at it when I'm back on the PC color wires are attached correctly but if motors color coding is not the same sounds like that could...
I got it from ratrig Portugal controller blackbox with the software from this website. it's a 1510 build belt drive. I adjusted the power on the...
x and y are doing the same thing. Belts have been tightened but motor is not moving when I try to jog it from the pc. I have attached a video and...
Hi guys, I am waiting for my workbee to arrive to start the build. I purchased this to mainly cut acrylic for a specific type of sign I want to...
