Separate names with a comma.
Some features disabled for guests. Register Today.
Problem solved, replaced the Black Box!
Hi, here a little video of my problem.
Yes, move up and hit the limit switch and than stop. Any errors in the serial log at that point? Where I see this? Is it there in the panel...
Yes, I home all. I don't see any G53 moves in the header, see attachement. I don't see any G53Z
I was repairing the wires of the probe connection, the red and black touched each other. I forgot to turn off the equipment. As a result, the USB...
I just bought VCarve desktop v11 and my CNC is Workbee 1010, Post Processor available for Openbuilt is Lead 1010. If I choose the one, does'it...
Thank you Perter for your held. I have no laser light and before I contact J Tech about this issue. Can you confirm that I did remove the right...
Hi, I need some held. I completed the installation by following the instructions for the Lead 1010. Now in the GRBL Setting, there is no...
Did you made this modification, I planned to make the same change as you. Are you satisfied with your new configuration?
I use Openbuilds controller. Normally when I open my g-code and I run it, my router will start too. But today it worked very well on the first...
WorkBee 1010 - Build Step 18 base Assembly. I tried to square the base assembly and I'm having a hard time doing that. I've been testing for two...
