Separate names with a comma.
Some features disabled for guests. Register Today.
I'm not sure there if there's a whole lot to consider? You really only need two exit points don't you? just one for your dust extraction, and the...
Great thanks, I appreciate all the info. I hope I'm not coming across as fighting your direction, I'm just slow to follow but do truly appreciate...
I'm sorry I don't follow what you're saying about moving parts and shutting down the rail? I was seeing 4.8v steady earlier but now there is no...
Unfortunately no. My blackbox and power supply are mounted side by side to the same post with no ability to move independently of each other and...
Well I think I found my issue today after trying some more. I tried to finish my job by doing it manually as I was just facing off an aluminum...
Thanks Peter, I was testing the power output from the blackbox at the interace side, and the power never wavered when the cord was jiggled or...
hi folks, I'm stumped, and am wondering if my interface (or my blackbox, or PS) has tapped out and said I've had enough? Like the title says, it...
Any chance you can get it warrantied? These things shouldn't just quit like that, you might have had a bad one.
Have you asked in the V1 forums? They're very active, I'd be surprised if someone hasn't done this along the way, 3 versions in now.
It seems like there's some mix up over what's the focus? I've never once considered how fast my lead screw/ball screws are turning, or what RPM...
I haven't tried a vacuum table but have tried many other hold downs, and I've reverted back to mostly ca glue and tape, and screws into my...
Good advice given, I'd also recommend that you go ahead and order ball bearing before you eventually drop one or ten on the floor and can't find them.
Well done, quite a departure indeed from the mpcnc. What are you planning on cutting with this big guy. It seems like it could be ready for...
If you're planning on cutting aluminum I'd look at spindles over routers mainly for noise, as you'll be running longer operations out of necessity...
Not really meant to be a build thread by any means but here's the work I was getting towards, nearly all wrapped up. Fun to see it go together....
Thanks for the info. I can see the lever lengthened and understand how that is worse than the over/under. I assume the bigger difference and...
Looks great, is your gantry extrusion a c-beam though? or 80-40? I'm imagining my way through what I hope is a similar conversion and right now...
Okay thanks, I'll take a look and see about the line segment options. I'm familiar with the option in fusion but not so sure about estlcam.
Well it comes and it goes quickly. I've continued to cut and had successes and failures along the way. Definitely get more leeway with a 1/4"...
Hi Peter, I might be thick here but is there a max line count? I've run into similar issues with trochoidal milling paths out of estlcam for what...
