Separate names with a comma.
Some features disabled for guests. Register Today.
Hi - you were right - thanks for that. Am now updated to 290 (and the probe still works!).
Aha right - will check on that. Thanks for the tip! Just happy things now seem to be working
It's now working. In settings I changed it to $6=Enable (it was $6=Disable) and saved changes to firmware. Your mentioning "that's opposite of...
Yes, it shows $6 as [Disable] / $6 = 0
And btw, I also checked there's no continuity between end mill and GND. When I run the Probe routine (after confirming position) the spindle...
Troubleshooting shows probe on (off when touching clip wire). I don't believe I have a short - the LEDs don't come on when the plate touches the...
[ATTACH] [EDIT: For info and to provide context for the references below, this thread was culled from a parallel one at: XYZ Probe Plus with VFDs...
