Separate names with a comma.
Some features disabled for guests. Register Today.
Thank you for the quick reply. I am just using a cheap trim router. No VFD/spindle yet. No way I am putting anything heavier than a trim router...
I built the 1515 with the high z and am struggling. Getting it setup I was optimistic because when there is no load on the router everything was...
I put a sheet of baltic birch down and used drop in T nuts to hold that down to the slots in the aluminum. Then I screwed these down to the...
Do you get much flex at the bit? I have a stock build and when the z axis is centered on the x I can flex the c beams a lot. I just bought a...
I'm in the same boat. Trying to figure out what is causing the issue. Live in a cold/dry climate. I am getting the machine setup so haven't...
For sure. I used 1100mm but I may run through the calibration for a slightly longer travel. Another thing that made it simple is I have a...
Thank you!! After calibrating I am in sub-1mm off. May need to work on tweaking it a bit but MUCH better now. As it wears in I will revisit it....
I got everything setup and did my first test cut. It seems that I am gaining steps over the course of travel on both the X and Y axis. I ran a...
When I try to set my origin off of the back right of the material via the advanced settings it probes in the X+ and Y+ directions (i.e. off the...
@Netechsys Do you feel that the 2.2kw spindle is heavy for the machine? I am leaning towards the 1.5kw but would like to have the capability to...
What spindle did you end up going with? I just bought the stock 1515 kit. Was thinking that the 1.5kw spindle with a 65mm body would be more...
