Separate names with a comma.
Some features disabled for guests. Register Today.
I changed my USB cable and lubed my lead screws. I tried homing and my x axis crashed. After looking at the limit switch, one of the terminals was...
I did some aluminum about 2 months ago and my feeds were way too fast and then again with the first carve yesterday. I didn't think to reset my...
Blew out the Blackbox, the cable ends, the computer. Changed the usb port i was using. Ran the file again without the spindle plugged in. Was...
Ran the file again. No lost steps but it disconnected. I have ordered a new shielded usb cable. I will post how that works out.
I turned the power down and I tried swapping the 2 y axis connection on the box to see if it is the motor. I will go through your other steps and...
Also, all my high voltage is on the other side of the bee.
No red lights on the Blackbox.
Hello. Once in awhile my y axis is dropping steps on one side. It did it on my first carve today. Also after about 20 minutes the Openbuilds...
I ran the wizard again at 46 inches and I was out .25 inch. adjusted the steps and I am less than an 1/8 inch out. I have done lots of projects...
Thanks for the video. That is what I have been doing, just on a much shorter length. I am going to try it on a longer run.
I truly do appreciate your suggestions Peter. I will check the mechanical fasteners. I am 100 % confident my process for measuring is...
Thanks for the input. My cut is set to outside shape and my bit is very close to .125. The most I would be out is a couple of thousandths of an inch.
Thanks Peter. I ran the calibration wizard multiple times and I only got it close. Too short and then too long, then too short, back and forth. I...
I have a 1515 running a blackbox. I am building drawers that are 22 x various widths. I have used the calibration wizard in openbuilds and on 22...
Yes. I had to rearrange my bed so it wasn't as thick. I had my extusions too high so with that, the .75 mdf and the thickness of the stock, once...
Thanks Peter. I am humble enough to have the basics pointed out. Sometimes it is the simplest things that you overlook and you just need a reminder.
I think I found the issue. The piece I am trying to surface is about 2 inches thick. I have a .75 inch MDF spoil board and I have the aluminum...
I run my spindle cable independently from all other wiring. I have ferrite cores on all my cables. All my wiring is shielded and connected to...
Hello. I have a Workbee 1515 with a black box controller and running the openbuilds controller. I have been running this since January without an...
