Separate names with a comma.
Some features disabled for guests. Register Today.
ok will do but would the slipping lock collars not make it shallow not deeper?
Good morning guys, I am running an opebuilds1515 setup with er11 router up until a few days ago all was going fine but it all of a sudden seems to...
ok thanks Peter i sent off a request for help. i am guessing this is not a normal issue with these
Has anybody here replaced the lower bearing in their ER11 router, we have about 100hrs on ours and it started making sounds that were not normal,...
ok i changed speeds to 3000 and acceleration to 300 i will pull all wires and insert again
i have it tracked down as to y1 motor is the one stopping
so try 300 acceleration y instead of 350 ?
so i loaded the grbl settings designed by you in the open builds cam control and it jumps even when not carving, the wiring is brand new and...
so no broken wires in the motors or in the wiring, grub screws were tight as heck as well as the coupler clamping screws any thing else to try
thanks man i will try this i sure hope no broken wires as this is a brand new machine and we are just getting started i will check continuity and...
good day Peter i am having issues with my 15 15 again it keeps on getting out of sync like one y axis stops for a second or two and it becomes...
Thanks Peter this seems to have been the issue and we did the swing arm but because we did not get an openbuilds table we modified a bit and made...
Thanks man this might be the issue as we fed the router power cable down the cable tray right beside the z motor power line and the micro limit...
Good day folks, i recently bought and assembled a 1515 machine. i was in the process of doing a spoil board and it started running into an alarm...
