Separate names with a comma.
Some features disabled for guests. Register Today.
Any thoughts re: the pwncnc spindles kits? Are they too heavy for a 1010? My concern is the brushes going during a long run and having to start...
Agreed.. thanks, you guys are great on service. I was looking for more info on the new black box, looks like it can drive more tools at the same...
I am guessing something like that must have happened. It looks like there is a new black box (I've been away for a while), is that fairly a...
I was just powering up my system after the winter... brought it up, moved the router forward, back , letf right.. all seemed fine (via Interface)...
Thanks.. I tend to jump back and forth between the computer and the Interface.. so didn't want to lose that capability.
I am looking at updating/replacing the Z-axis I understand calibration in Control.. but does that automatically apply to the Interface? Or is...
Did some testing last night and you're right, it works well from the flat of the collet. I would recommend updating the image in the Probing...
Experimenting with the new Lead 1010. Learning from SpindleTV and Mark Lindsey on Youtube. This looked like an easy experiment to try out some V...
I was having trouble getting signal through some of the bits at the time, but I was newer at this. I'll try the flat of the collett at let you...
btw, I found the magnet was just not usuable. Would constantly slip off when probing x/y. I added an aligator clip probe wire I had around and...