Separate names with a comma.
Some features disabled for guests. Register Today.
I disconnected the external power supply and went to the openbuilds power supply (wasn't sure if could handle the extra 6 amps for the laser)...
Right now the separate power supply hot and ground go directly to the laser, should the power supply ground be tied in to the PWM ground?
I will change $110 & $111 to 3000 mm/min and see what happens "Some times when I turn on the machine before connecting the USB cable, the laser...
Hello All, Laser noob here looking for input/help. I’ve added a Lasertree K40 40W diode laser to my 1010 workbee running a blackbox controller,...
just to confirm wiring like this?
thanks again for your help Peter
thank you Peter, bear with me for one more noob question. Can the coolant signal be split to another IO T relay one relay for the air pump and...
where else could I get the signal from? the only other port not in use is the relay and the door, would one of those work? If so do I need to...
"Can I run the air pump off of one of the other terminals on the "head terminal" socket since I am only using the PWM and ground?" does it matter...
I'm adding a 10w diode laser to my 1010 open frame cnc running a black box. I'll be using the toggle switch to switch from cnc to laser. I have...
Having nothing (productive) to do one day at work, I stumble on the high Z mod discussion here on OB. I was intrigued on the topic but since I...
I'll take a look at both of those ideas, thanks
I had one of these dust shoes that I adapted down to 2-1/2 hose, I did have a hanger ( I used a cell phone holder to hold the hose) for the hose...
Ok, on a whim, I removed the dust shoe and reran the cut...viola an even bottom. I'm guessing the weight of the router, the dust shoe and the...
Ok, there was some slop on the Z axis, I rest the lock collars so everything is tight now, I set the step over to 50 and the imp to 75, .040 total...
I am away from my shop at the moment and be back later this afternoon and check for movement and post the results. I have the rmp set at about...
Thank you Rick, Here are the current settings I used for the cut total depth of the cut is .040 1/4 bit new feed rate is 40 ipm step over is 75 %...
this is what it's supposed to look like and this is the carve I'm getting, I wrote in where it was supposed to cut but didn't. Any suggestions...
thanks Gary, my $1 is set at 255 the cnc has been trammed and I surfaced the spoiler board. If you look at the larger picture, (rotate it counter...
thanks for the response Gary, it's an upcut 2 flute bit, the total depth was set at .040 with cuts at .028, how tight should the wheels be and the...
