Separate names with a comma.
Some features disabled for guests. Register Today.
Well to close this out (I thought I replied with the solution to the issue but it didn't post)... I disassembled the z-axis to figure out if...
Maybe instead of boring out the dog holes, I cut them out with the same 1/8 bit in passes That was my first thought that the bit was being...
The one that works (Basic) uses a 1/8 inch bit. All in one job, it first does 4 pocket boring holes on the corner for inserts, then 12 drills...
well I ran another job 8 times that predrilled 12 screw holes, 4 insert holes and carved out a handle with no issues. I thought maybe 10% boring...
I am not sure what is happening. I home my LEAD 1515 (yes I have the Lead 1515 loaded in the Touch) I probe to zero the XYZ Here it's probed....
I have a usb drive for my lead1515 cnc with a folder called Gcode (Probe is another on this level). Under this folder I have project folders that...
That is correct.
Just to make sure I shut everything down and turned it on, Homed it, probed it and ran it. It looked like it was going to work but it only made 2...
For starters, I installed the latest OpenbuildsFusion360PostGrbl.cps post-processor in fusion 360 and have the latest firmware in my interface...
I let fusion 360 have it's default of -10mm and the problem went away. One thing I discovered is I don't have a problem with the original gcode if...
I have a Lead 1515 and generated gcode with fusion 360 with the OpenbuildsFusion360PostGrbl.cps V1.0.31. I can't figure out where is it telling...
So my assumption is the probe is setting the zero point for x and y based on the middle of the 1/4 inch reference bit. If you set that and swap...
After about a year, I finally got my Lead 1515 set up with a black box and interface touch. Designed in fusion 360, I carved out the tracks and...
Thanks so much.. within a half hour, they had a new one shipped.
I have been trying to get the Touch control system to work properly for months with a USB. Every time I go to use it, it doesn't recognize the...
Thanks for your insight. I downloaded the software as you referred and ran the program for the lead 1515 in the interface and not only is it...
I have been building my Lead 1515 for about a year now and am in the final stages. I am using the Interface Touch with the black box and...
I have the Black Box controller wired correctly to 3 different limit switches. If manually press the limit switch, the red light comes on but if...
Every motor works fine along with it’s associated wiring as long as I don’t plug them into the y2 slot of the black box. If I take the vibrating...
I have my lead 1515 all set up and wired with a black box and interface. I have everything wired correctly but the y2 motor when connected to the...
