Separate names with a comma.
Some features disabled for guests. Register Today.
Turned out to be a ground issue. Once I connected a wire from the metal tubes to the dust collector it all seems to be working fine. Ran few times...
Limit switch fixed! Even replaced the LED as it also got smashed once. Got 3 brand new switches if a quick replacement is needed. Machine is...
True, true! First timer. Took me a while to get to this point as I was having issues with Fusion 360's 2D Face. It wanted to plunge from the front...
Sure will do! Feedrate was 2000mm/min, RPM at 4 on the dial.
I went 1.25mm. Might have been too deep?
Got to a point where I managed to run e full job (after a day full of head banging) of facing the spoil board. From what I've learned so far, the...
It's probably worth mentioning that I haven't surfaced the spoil board yet!
I somehow managed to get it relatively square front to back. Left to right also looks descent but while front to back is bately touching, left to...
Bought the machine from Ratrig. Didn't know it's not an Openbuild's part. What you're saying leads me to beleave that everything else with the...
I am also having some trouble tramming my router. My Z axis gantry plate is perpendicular both ways front to back and left to right to the MDF...
You're right! I just wanted to make it look as oem as possible. Using the p/n listed above I was able to find several switches with the same...
5A 250V, 10T65. This is what I was after.
Thank you for the reply! I am sure soldering itself would not be a problem, I was mainly asking what the specs of the switch are? I haven't...
Managed to crash into the Y axis limit switch last night and unfortunately this was the last time for it (Don't know why it happened! I extended...
Well! I tend to have a good handwriting but my X and Y are really close when comparing. Soo what I've done is, I've marked all cable ends to be...
Honestly I am a bit lost. Shouldn't be I updating using: Spark-Concepts/xPro-V5 for firmware update. If yes, it's been updated.
Hello, New to the forum! I've mainly using it in the past few weeks for troubleshooting but ran into an issue that I can't resolve. Just...
