Separate names with a comma.
Some features disabled for guests. Register Today.
[ATTACH] I checked the list in the dropdown & Openbuild GRBL is not on it . I have bought the stand alone separate PhotoVcarve program , not the...
Hi folks. I just purchased PhotoVcarve from Vectric . I am running an open builds blackbox with touch controller & it asks what post processor I...
Hi. I am having trouble wrapping my head around zeroing xyz using the OpenBuilds XYZ Probe Plus with the INTERFACE CNC Touch . On normal endmills...
Where do I find the max feed rate in the grbl settings
I set it super high just so I could visibly confirm it was not going faster . The speed it is travelling right now is no problem , no deflection ,...
I have set my movement & plunge rate very high in ASPIRE ( as shown inn picture ) I then put the project on a USB & take it to my Openbuilds Touch...
Thank you , It can't get any easier than that
Thank you, that is very helpful
How do I program in a new bit size ( Tapered Ball Nose - 4.8 Deg Tip 0.5, 6.35 mm for example ) into the Openbuilds Touch Interface ? I need to...
Thank you
that's way over my head .when it is just an overrride feed & speed on the control with a plus or minus .It is an Openbuilds product so I would...
I can find no information about some of the controls on the interface . For example , once a job is running I see where I can increase the Feed...
also on the documents portion of the Openbuilds page [ATTACH]
The video on the OpenBuilds page for the XYZ probe needs to be changed. It shows putting it on the bit
very smart . I just got my xyz probe & was wondering how I was going to keep it out of the way when I was not using it
The magnet on my new XYZ probe can barely hold itself onto the bit. Anyone else have this trouble ?
It’s why it wasn’t connecting that is the issue .did not recognize it . Followed openbuilds instruction on BlackBox to install drivers but the...
I have taken the computer to the machine , connected the black box to the computer but the Openbuilds wizard does not allow me to open up the...
th This does not answer my question though, How to do I do that when I have the touch controller, the only interaction between my computer & the...
How do I calibrate my stepper motors with an Openbuilds touch interface ?.The computer is in a different area so how do I load commands onto the...
