Separate names with a comma.
Some features disabled for guests. Register Today.
I am at a complete lose here. I change my steppers from 1.8 to 0.9 and replaced the pulley with a 16 tooth. I am trying to get the wheels tighten...
OK I figured it out. I had my Blackbox plugged into computer with USB I did not need to do that.
I have a Millright CNC i am trying to use the Blackbox and Interface with. My machine works with the Openbuilds Software and the Blackbox. I have...
Do you have any recommendations on where to get stepper motors i found a place on Amazon but not sure on amps. It says a 2a but not positive.
Little more help maybe needed. I installed my .9 Steppers. These motors seems to be running warmer than the 1.9's My temps are 118 degrees to 125...
Thank you.
I have the ACRO system with the BlackBox. I am using the NEMA 17 steppers 1.9 with 14 tooth pulleys. I would like to upgrade and was wondering if...
Can you tell me is that the $100 &$101 values i am changing. I engraved a 25.41 x 25.41 mm square measured it at 34.22 x 33.67mm I calibrated axis...
Thanks I looked at that last night after this post got it better. My Preview an engrave gave me a time of 45 minutes to engrave. It took me 1 hour...
Thanks for all the help I got them cooled down. I adjusted the current. My only trouble now is it does not seem my feed rate is correct. I had a...
Well I thought I had it working. It seems to be OK in the control software. I know it will be different in Lightburn. X Axis seems to be good. The...
Ok got it working. Even got laser working. Wiring color code is way off. Just need to get the origin right in lightburn.
OK I Changed the $3=1 and that works for direction. I changed $23=1 and the X limit is good Y is still backwards. I will move that limit switch....
OK I will try thank you.
OK I have found the wire layout and got it hooked up. I am running into other trouble. When I watched the for the wiring and using the Control...
I bought the Neje Master 2s Max 30w. I have had nothing but problems with there main board, I switched to the Openbuilds Blackbox. I want to use...
