Separate names with a comma.
Some features disabled for guests. Register Today.
Update: just ran 1hr mill job. No issues. So back to an earlier recommendation...speeds?
I ran the test again in the default (non-lase) mode. The machine did not grind to a halt.
Gary, Thank you for your continued help. Right now, using OpenBuilds LEAD 1010 with Laser Module default settings. Pics of actual settings attached.
Okay. So I checked wiring continuity to the motor I thought was having issues (right side y-axis) using a meter and attempted to "break in" the...
Gary, Sorry this response has taken so long. Personal issues have kept me from my shop. After removing the X/Z-axis gantry, I adjust tension on...
Okie doke. Lots off trial and error. Lots of cursing...lots of cursing. I am cautiously optimistic that I've fixed the problem. David feel...
Thank you Sir. I will give this a go!
Hello CnC Gurus in the Sky, Been using my 1010 for just over a year now. I recently started having problems and am looking for help. I've...
I checked all the set screws, didn't find any loose ones. I had not changed any speeds, but did find a little dirt on the wheels...cleaned those....
Ok...I must have gremlins. I'm working on grounding everything. Running a copper wire through the dust collection system. In the meantime, I...
Thank you Sir. I will looking into both and report back.
Peter, I tried to switch to using OpenBuilds CONTROL software to run my machine. I tried to different smaller jobs, both ran fine. Went back to...
I wanted to follow up for others that may find this thread. FIRST, I submitted the ticket and a new interface showed up in my mail box within...
I submitted a ticket. Thank you!
That is the power supply I'm using. :(
I searched in the forums couldn't find my issue. Please forgive me if it's in there some where. Here is what is happening, I think these two...
Sure enough, there was a line. Thank you Sir. In addition to being conservative with the amount of material (depth of my cut), is there anything...
Update: Tried two things and one or both did the trick. (I know one variable at a time...grin). Recently pulled my router out to replace brushes...
Good Day All, Working on a project and experiencing some issue making holes...grin. Simple right? I'm still new and learning everything on my...
I used the calibration wizard and calibrated all three Axis. Z was good to go, but both X and Y were slightly off. I'm continuing to test....
