Separate names with a comma.
Some features disabled for guests. Register Today.
i swapped the y and y2. At least i can jog the y using the a jog from control software.
It has not failed. The point is I upgraded to x32 to use full functionality of 4 axis. I am testing wrap and rotary demon now. It can work, better...
Maybe the newness of grblhal and 4 axis capabilities. I have sent a message to them to find out if they have one. I am awaiting a response. Im in...
or a post processor for deskproto
I understand full well the complexity of the task. There are gadgets in vectric to do the wrap. Perhaps that same thing could be done to convert...
Im ok with a paid option. I dont want to have to continually pay for something i use once in a while. I have even put feelers out to find someone...
Sorry, I am just a little frustrated to not be able to use a true 4 axis set up. Im researching deskstop proto, as i really cant justify the...
So this controller has been around for almost 3 yrs and no one has written a vectric post processor for 4 axis?
any idea when this may be available?
Im not finding a grblhal post in fusiion 360. Please advise
I'm sorry, I know your already answered this. I was hoping there would be another way. It seem F360 is my only choice for a cam that i have found....
Any update on this? The x32 is capable of true 4th axis machining and the firmware allows it, there is not a really viable way to make it all...
i will check with vectric and go from there.You may be right about the actual 4 axis support.......
the mm post does not work with the rotary. I have all my axi moving and calibrated to eliminate that question. all axi moving when manually...
i will try. i will convert and save in mm. the Inch version does not work and the rotary demon version does not as configured
Is there a rotory post prcessor for this yet?
Past that hurdle, to find the source of growling ball screws….
thank you!!! I had just fount that in one of your earlier posts. Im thinking it is at the plug. 2 wires is a tight sqweeze
ok Ive got it connected and the firmware is up and running. this is a ball screw setup. now the issue is when jogging y, one side moves before the...
Is there a diagram of the wiring for this and do two wires need to be reversed for one of the y motors?
