Separate names with a comma.
Some features disabled for guests. Register Today.
I think I'm giving up on this blackbox controller. I think it's an internal problem. I can never turn it on and it works and it always goes back...
I've been having an issue since I got my blackbox. Initially it was for a cnc newbie and it was always a problem with the z axis. I would...
Thank you. I found it. $13 was disabled. It's working good now.
I'm not sure what the first link is. I'm on my phone, maybe it isn't showing up right. I calibrated when the issue started. When that didn't work...
I'm using an old computer and therefore older software, 8.5 version that works with it. I can't update. It was working well for a while, I updated...
I'm homing the machine. I'm not using the OB post processor. I tried installing it but I'm getting an error.
I don't have the offset checked, is the problem
Everything was working fine until I upgraded to the new OB software I was using version 1.0. 30. On an older computer. Cuts are now higher up on...
These are the stock xcarve values from inventables. $0=10 $1=255 $2=0 $3=3 $4=0 $5=0 $6=0 $10=115 $11=0.020 $12=0.002 $13=0 $20=0 $21=0 $22=1...
Some of the settings were actually wrong. I got it from the inventables forum, later in the thread the guy said it was after he calibrated and...
At first yesterday, nothing was moving and I saw in the forum you said change $4 to 1 and that worked for everything but the Z. $0=10 ; Step...
I installed a new bearing, so I put the entire z axis together yesterday. I have a spare steppers for the xcarve so I disconnected the one on the...
So I'm back again. I tried everything then I got fed up. I have a 4848 cnc4newbie. I also have an Xcarve 750mm stock. I put the xcontroller on the...
-Z axis is mechanically sound, it was the first thing I checked. -Acceleration and max rate set correctly -I also changed the wiring and checked...
Why is it that everytime I need to calibrate my Z axis. Sometimes it works sometimes it doesn't and I have to re-enter the values for #102 because...
Why is everytime I need to calibrate my Z axis. Sometimes it works sometimes it doesn't and I have to re-enter the values for #102 because it...
