Separate names with a comma.
Some features disabled for guests. Register Today.
I would like to thank you for your time. I just tried to make a video of the problem and it worked every time. I just did it four times in a...
Thank you, that is good to know.
I will work on a video. Go to zero is push the "gotozero" drop down and select the work Coord one, (G0 Z5, G0 X0 Y0, G0 Z0) option. when I use...
Normally, home machine set g28 and g30 locations. Use xyz probe to set z for height only, I like to use the center of the wood as center of...
Good evening. I was just checking to see if anyone else as tested the tool offset macro in with X32. I can use it one time it will work great. On...
I just want to let you know, I got it figured out and it is square within .73mm when homing. It was a lot of work and I think I'm going to change...
Firmware compiled and uploaded finally, not to get the coolant pump to not come on when move the y+ axis and to work with the M8 command had it...
Thank you , I was just thinking that I as I was driving home. Wish this would have happened yesterday, I spend two hours trying to get it to...
I have the 4x. I think I got the firmware complied but when I try to upload the .hex in openbuilds control it will update failed. it says...
I think I got the homing switches to read properly. I moved the jumpers from Y for slave to A3/A4. I have defined dual axis homing and dual axis...
I have 4x, for now have the x32 just have not installed it yet.
Thank you, I have done it before on another machine so I think I can fumble my way through it again. Is there a wiring example on how to wire the...
were you able to get this to work. i purchased a new switch trying to figure out how to connect the limit switches and see if there is firmware...
wifi works without usb on interface now. Thank you. no way to bypass the naming limitation on interface usb uploads?
on 1.57, I will look at retrofit
I have the interface. Currently I use interface to control the machine but Control software to load file and actually start machine. I dont like...
So Wifi is not a good way to go? This is the primary reason I purchased it at this time. I have a USB cord running from my computer to machine...
I am currently on newest OB control, could it be an OB. I can connect and see X32 via web settings in a browser. I'm a little lost an...
I deleted and reset everything again, and Now it is connecting via wifi. Not sure why.
I checked the $$ and it does have an IP address and it connected to my network, however I cannot connect to the X32, either via bluetooth or WIFI....
