Separate names with a comma.
Some features disabled for guests. Register Today.
thanks :-)
So I finally figured it out, I had some play in my X motor pulley, It were invisible to me before I found a way to lock the motor. Thanks your...
So unfortunately, the bearing switch did not resolve the spacing issue (Figure A). However, I noticed an interesting thing: the lines with issues...
I think that the shafts are stainless steel, but I will check both shaft and bearing I have bought
The machine is square, possibly off by half a mm on the Y axis. Regarding the pen holder, I conducted more tests and noticed a very small amount...
I rotated the piece 180° and redid the plotting. It seems the issue is more relative to the piece itself, not relative to the plotter. However,...
Yesterday, I retightened all the V-slots and belts and increased the density of points in my G-code, which resolved some issues. However, I'm...
Everything is very tightly secured. Is there a possibility that my V-slot is too tight? The X-axis seems a bit harder to manually move compared to...
I'm currently facing a recurring issue with my OpenBuild Accro 1015 plotter, particularly with the spacing between curved lines. Any tips or...
I'm currently facing an issue with my Pen plotter based Openbuilds Acro system, and I would greatly appreciate your expertise to help me...
Peter, I get it, my question are a bit silly I'm sorry :-). I will try to ask a better question : I'm sending M3Sxxx and M3Syyy values to my...
Peter, Thanks for your help, and I'm sorry for asking more question but I just want to be sure that the Interface could fit in my workflow. I'm...
thanks for the answer, so are you also able to adjust the pen down and up value ? while executing the gcode the values come from the Gcode file...
Can the Openbuild interface manage to send Pen UP and Pen DOWN M3 command to my pen plotter made with an Accro system using a blackbox ?...
