Separate names with a comma.
Some features disabled for guests. Register Today.
ok. I'll look into that. Here is the g-code that I'm using. Cut with it this morning and it worked.
I did some messing around. I think it's a perspective issue with the 3d viewer. I'm not sure why each part is on a different "layer." But I...
Ok. I'll look into that. Yesterday I nested about a dozen parts and it worked fine. Today I went to cut the rest and ran into this problem.
I'm using Sheetcam to nest parts for my plasma. I output the gcode as a .tap file. Then open it in Openbuilds Control. The 3d view shows parts...
I've been struggling with hit and miss USB disconnects while cutting with my plasma cutter. Sometimes it works fine, then I'll get disconnects...
How do I keep Fusion 360 from adding the G53 commands below? Those cause issues with my gcode. Without them, the program runs fine. With them,...
Also I currently use M3 to fire the plasma, the SketchUp cam has M5. How do I change that?
Ok. Calibrated the steps per mm. It was the arc issue; I drew a rectangle in Openbuilds and it was must faster. I downloaded Sketchup Maker...
My x and y speeds on my plasma table are not following the gcode. I cut a 60mm diameter circle and it takes 27 seconds. That is about 500...
I changed PCs from the one I use to run SOLIDWORKS to an old one that I factory reset and now only use for open builds. So far it's worked flawless.
I switched 120v outlets that power the open builds controller and it now cuts. Not sure if that was it or just got lucky...
I tried using the new Cut60 to cut a part on the table. After the pierce, I lose connection to the laptop. It's my understanding that this unit...
Do I use the Laser on/off M3/M5 setting in the software for the Primeweld Cut 60 CNC port connection? I see there is also a plasm on/off. The...
Thanks for the lightening fast response!! That worked better. A couple issues. 1) The part was made in SW. About 2" x 2" overall. When it...
I am struggling and have been searching, but just can't the image in CAM to look like the part. I created a part in Solidworks. Exported as dxf....
I have a primeweld cut60 that I am goimg to use with my open builds setup. It has the black box 4x. I see the start/stop for the plasma in the...
I use Solidworks for my modeling. I create a dxf from SW and when I open it in the Open Builds program, all the radii are inverted. I've tried...