Separate names with a comma.
Some features disabled for guests. Register Today.
Well you'll never guess what happened, it works! I'll definitely give it a read and thanks another for you patience
I did not know that!!!!!
Looks like my $120, $121, $122 is 150mm/sec² and my $110, $111 and $112 are 2500mm/min. Looks like it says I need to slowly increase the speed for...
Cool, I did check my connections and fittings and that looked good, but it doesn't hurt to check again. What's the recommended acceleration/max...
I reloaded my original back up and it seems to be working now. It was strange because I didn't touch any of the setting and after I did another...
Well looks like it only does that if I have the power supply going to it as well
Okay so now I have an issue with connecting my pc to the black box. It says no firmware detected using the openbuilds control software
Sounds good, I also reset my grbl and it looksblike it's calibrating fine now. But during my last calibration wizard with the z axis it looks like...
I made a backup, where should I submit it for review?
I'll double check my set screws and try a different wire since I have some spares. What are somethings I should check with the grbl settings to...
I haven't checked the set screws but when I visually observed it it looked pretty solid with no slipping when it did move. And when I would put in...
Hi! I was using the calibration wizard on my laptop controller for my 1010 style cnc. I use the black box. I forget which model but it's the one...
I read somewhere that the limit switches may be a problem too. So I decided to disconnect all of them and looks like the problem went away. So...
I have the latest firmware. When I brought the interface and Blackbox inside to connect to my wifi I noticed it wasn't doing it. And I've tried to...
I've been having problems with the touch controls on the interface for my build. When I first got it it worked great but after a couple months the...
So I just got my machine up and going and I wanted to test out the xyz probe. It looks like the light comes on even when the probe isint touching...
looks like my x is a doubled 2060 same with the z axis. looks like I'm probably going to be making a smaller version of the 1010 and i can re use...
I was thinking about it and the main reason i want to switch to a lead system is the belt driven style i have has a lot of chatter when it cuts so...
These are all really great! Thank you! I might try and combine the tall ox and the one from Daz so I can get more z axis. Or worse case I buy 3 of...
So I bought this cnc off fb marketplace a couple years ago. The guy built it from open build parts. It uses belt drives for the x and y axis, and...
