Separate names with a comma.
Some features disabled for guests. Register Today.
Ive always used my laptop with my openbuilds control. I got a bit sick of bringing into my workshop and while having a look in my attic found an...
Hi I'm in uk so it's 3 pronged plug and no way to change L/N round. It's a moulded plug into mains AC and the same into charger so factory done. I...
Thanks I will start using the bottom left from now and treat it as the norm
Thanks yes I tried that, but then it asks for stock measurements of the material so it can put an offset? Do you have to do that everytime?
I used to use the Openbuilds Interface on my cnc machine. I had lots of trouble with it crashing etc and touch buttons doing there own thing. I...
I've always used bottom right corner for my datum point. I tried the zooen builds xyz probe and by default its the bottom left. Is there a way to...
The power supply was bought from ratrig a Meanwell power supply. I've unplugged the interface and running it on my laptop at the moment and it...
No, the new cable didn't change anything. It either crashes if you try to jog, if you press a job button say z up, one of the other buttons lights...
I've tried to do the device test mode..I have version 1.52 I plug it into a USB c, when it starts up I hold the MODE button and it goes into a...
Thanks I've replaced the cable from control to interface, just the same problem. Suddenly it starts working, next min you press z axis up and the...
Thanks I will set up the WiFi tonight, wonder why it's not searching for WiFi now?
Hi thanks i never did set up the WiFi, when I first installed the blackbox control I had no WiFi close enough. I do now, is there a link showing...
It's in a heated outhouse so just the normal temp it is kept at most days. Not dry or wet just steady temp Thanks
Hi yes, I turn the Blackbox on, I jog using the interface. A finger on the direction button it starts to move then the interface crashes and it...
I can start my blackbox controller and interface and it looks fine. As soon as I jog using the interface it starts to jog and then crashes. I have...
Hi I set the min at 0 and max at 24000rpm. If the Blackbox is not turned on the spindle stays stationary. So I assume the Blackbox is outputting a...
I've tried it without the Blackbox on and it's fine without the control
I've set up my Openbuilds Blackbox to control my VFD and spindle. I've calibrated the 10V output from the openbuilds Blackbox. When I set the...
Hi thanks the laptop is connected to my WiFi but still the choice of versions is blank? In the end I downloaded version 1.52, it had 1.43?...
Hi tried to update the firmware from the laptop going through control wizard. Connected from laptop to Interface. with an USB to USB C I choose...