Separate names with a comma.
Some features disabled for guests. Register Today.
but cutviever also did not had any issue with that gcode and it is supposed to actually simulate the cut. I also did not find the small loops in...
Update, with the nodes/points moved a bit all Gcode with G3 arcs worked fine. I still wonder why the visualizer was showing that all is fine but...
Thanks for suggestions. I wonder why cutviever or ugs visualizer does not show/detect those arcs. In the past I remember seeing those in mach3. It...
Hello. I have this gcode: G21 G90 G40 G91.1 G0 Z25.0 ( T0 : 3.175 ) ( Tool Taper coming soon ) ( TOOL/MILL,3.175,0.0,0.0,0 ) ( Profile1 ) G17...
The tool diameter is fine. That was the first thing I checked. No idea, I compensated for this in tool diameter and for my use its ok. I tend...
Good point. Did not checked that before. After checking all looks ok. Seems that I assembled it decently. Tramming looks good all is square, the...
Calibration was done over the span of 600mm. The bit is 1.5mm. The slot was supposed to be 6mm. Is 6.5mm. Similar difference is on bigger...
Also one more note: If I just do a very gentle cut, like score light it also is 0.5mm too big.
Calipers show 1.44 to 1.56 depending on the location of the measurement. Its plywood and calipers dont measure deep. Made a photo of the cuts,...
I did the calibration in UGS. There is a wizard for that. Yes, I measured the bit. Its the same as in cambam tool definition. If the dimensions...
Hello. I have an openbuilds lead 1010 machine (bought from makerparts.ca if that matters). I use UGS as gcode engine, black box as controller,...
