Separate names with a comma.
Some features disabled for guests. Register Today.
Everyone - thanks for your help on this. I think I figured it out. After running the wizard I disconnected Control, reset the controller and the...
I have checked those things. I haven't checked backlash - not cutting anything yet. However, I am sure either of those things would have...
Gary, I have an older Workbee 750x750 w/ lead screw (I got it from SPAM a couple of years ago). It is smaller than the profiles in Control. I...
Hi - I am struggling with calibrating my Workbee. I have X32, Control, Interface, Meanwell PS. When I run the wizard, I home the machine - then...
RESULTS! I must have been in a hurry when I did the initial setup on calibrating the 0-10v. I redid it and now I see 400 on the VFD at 100%. I...
Peter - thanks for the quick reply. However, I think I should have worded my post a little better, apologies. I will try again and with new...
I have done the above wiring and setup, with BBX32 and YL620 VFD. It works. Thanks!! I can change the rpm with OB Control tool menu. However, it...
I know this is in response to an old post - but just in case anyone else runs into this issue. I was having similar issues with trying to connect...
Good info/answer, Thanks!!!
I went downstairs to duplicate the error so I could get the proper syntax and had an epiphany ( I think). After homing I set XYZ zero to that...
Would you mind sharing your finding? I am having the same issue. Thanks.