Separate names with a comma.
Some features disabled for guests. Register Today.
I have started from the lowest setting to the highest and then back down again, took 31 up and 29 back (increments, so I must have moved it a lil...
"I have incrementally changed the pot and restarted with no change." - as I wrote above.. Z current adjustment comes from factory at mid point, X...
I plugged the X Drive into the Z on x32 and it would not work, same issue. I plugged the Z motor into X on X32 and then tried to move in the X...
Apologies, I see this error on here before, maybe I have more I can add. Received the X32 to replace a x4, of course went down and started...
yes the ortur runs the 32 bit. the .1 happens to be the size of the laser (actually .06 but it looks better at .1) I feel as though I would...
Yes I do have a Z axis, but unused other then focusing. Here is the Gcode file attached, I do not see any Z movements.
So overnight I ran a little test, I saved all my settings, wired up my ortur with the blackbox 4x to simulate the ACRO system, did not connect a...
I found a listing for the machine I have (Amazon.com) Mind you I use this primarily for 3d wood engraving and large laser cuts. So workspace is...
I have not really done any tuning other than $100-$102 to get proper shapes. This machine was MACH3 controlled, but I changed it over to the...
[04:01:02] [ ] Grbl 1.1g ['$' for help] [04:01:02] [ ] [MSG:'$H'|'$X' to unlock] [04:01:04] [ $$ ] $0=10 ;Step pulse time, microseconds...
$32=1 - yes M4 Power Mode - yes (default for Lightburn GRBL machine) Gcode Snippet: { G00 G17 G40 G21 G54 G91 M4 ; Image @ 3000 mm/min, 100%...
So I have dove into doing some 3d Grayscale laser engravings. When using the Ortur Lasermaser 2 the thing happily runs back and forth like a cute...
