Separate names with a comma.
Some features disabled for guests. Register Today.
The black box is fine so I’ll put it on eBay As I got a Ruida rdc6445g/s I like the dap controller
the potentiometer is working fine because it will go from 0 to 4 ma and if i test it with L on the power supply i get 0 to 30+ Ma
ok cool ill to grab one
i dont have a Multi-Meter to hand right now
and im getting 4 MA at max position
i have wired it just like the pic
hi yes its all working fine ,but now i cant get the laser to go over 4MA @100% Power do i need to change something in the settings ?
i cant get the 50w laser to go over 4MA @ 100% power?
hi yes i got it working now ,but i cant get it more than 5ma at 100% power?
hi i did the wiring like that but it don't work the Co2 laser stays on and wont go off With the PWM to H = weak laser beam with the PWM tp L =...
Gareth90 published a new build: Y-1200 Build The Y-1200 has a cutting area of 1200 x 600mm and the main chassis has a external size of 1620 x 955...
Y-1200 Build The Y-1200 has a cutting area of 1200 x 600mm and the main chassis has a external size of 1620 x 955 x 450mm. The recommended power...
I have a Cw3000 Water chiller So do I have to use the flow switch as I think it as an alarm on it
so is this how i need to set it up?
so don't need to use DIR or 0-10
hi so i need to wire GND to GND PWM to H and then wire up a potentiometer?
So what’s the best way for me to wire this up as I’m not to sure on how to ,is there a wiring diagram I can follow
I just got it used and this is how it was ,I’m not sure how to set it up to be honest it’s a 50w laser build just trying to get it all runing...
Not sure if this is right
I’m a bit stuck not to sure on how to wire up the laser , blackbox to the power supply I have tried GND to GND PWM to 5v 0-10v to IN
