Separate names with a comma.
Some features disabled for guests. Register Today.
Embarrassed to say this was a simple mistake of not following instructions properly... lesson learned! Really appreciate the help and guidance...
so this is what i tried, DWC was not working so i removed the config files via SD card www folder and added the Workbee files, when i did this on...
I uploaded the V1.0.7 firmware on DWC... I just wonder whether I should have removed anything else I had stored there not assuming it just...
I've uploaded the Workbee firmware via DWC but still seeing the same code as above in the config.g. Sorry, still learning as I go along here, but...
I think I may have made a mistake when switching from the Ooznest assembly to Duet3d set up, and going further with the latter instructions. I'm...
Thanks Alex, the section below is what's currently in the config.g.... I'm yet to get to the stage of configuring as I've been stuck with this...
thanks Alex, I test the motor and the wire on another axis as you suggested and both seem to be working fine. I do have the latest RRF3, where...
I have a Workbee z+1 with duet3d wifi using DWC. At first one of the Y axis motors was jerking and lagging behind the other, now it is not...
