Separate names with a comma.
Some features disabled for guests. Register Today.
Hi Peter, As always, thank you for your quick reply. I have the same issue with all my bits. I have just confirmed the bit used for the pictures...
Dear Openbuilds forum community, I have an issue. Pockets always seem to be .2 mm too small, while outer diameters are almost spot on. Please see...
Hi Peter Thank you once again for your prompt response. The last message is from stopping the job. I get that message every time I manually stop...
Hi Peter I have now made sure my CNC is running on a separate electrical group (not sure what the correct English term is, but it is isolated...
Dear OpenBuilds forums, I have a very annoying issue that has ruined many carvings now. :( I have problems with other electronic devices...
Thank you all for your input. I have found the issue. Before probing I have it set Control to Incremental Jog. After the probing, it actually...
Hi Alex, I have the 16 bit Blackbox, not the x32. OpenBuilds Controls says it is the lastest firmware, I have not seen any new in a very long time.
Downgrading to Controls v1.0.367 does not help. Disconnecting and reconnecting does not help.
Dear all, I have an issue. When I start OpenBuilds Control and connect my CNC everything is fine. If I step 10 mm the CNC moves 10 mm. If I...
An easy answer, but fair. I will buy a new computer. Have found a cheap i5 12500H. Should be a lot faster. Do you know if there are some...
i7 7500U, 16GB DDR4 ram, Samsung 980 SSD
Dear OpenBuilds forum I have issues with high CPU usage when idle or running from Open Builds Control. When I have homed the CNC it seems that...
Hi Peter, Thank you very much for your reply. I am trying to get in contact with the seller. /Martin
Hi all, I have been running my machine for quite a while now. I have never had issues with my limit switches. But all of the sudden when I went...
Hi Peter. Thank you for your quick reply. I don't think the voltages I am getting are fairly accurate. Do you believe they are within acceptable...
Dear all, I am using the Blackbox to control a AMB (Kress) 1400 FME-P DI. It is wired up to use the 10v analog signal to control spindle speed....
