Separate names with a comma.
Some features disabled for guests. Register Today.
That does state "[ATTACH] indeed, completely missed that, thx
Question; if you have the doorsensor enabled in the firmware. When you run a job, it will succesfully trigger. But when youre not running...
@TopDawg1750 just wondering; how did you manage to use NC switches in parallel? (Or am i reading your posts wrong and you're currently using NO...
And i see you moved my other question in the macro to this thread, but that only counts for the 'related question'. the showing of...
oh absolutely. And i thought i had it figured out, locked it up; and it ran fine for a few jobs. Turns out i didnt. and yes it is either...
Since my latest machine update, the BBx32 is out of direct view. I've had a couple of moments where one motor is stalled. While the box is out of...
Plenty of room here on the right: [ATTACH] Would it be possible to show the troubleshooting triggers there? [ATTACH] And on a related...
This post is just to help people finding this thread in the future. grblHAL Webbuilder defaulted to BBx32:...
Oh sorry i meant the 'optional checkboxes' on the webbuilder, not inputs on the bbx32. But good to know the 'mode' button is (sometimes)...
Thanks for your replies. I have checked the available info, but none made it clear if it was available on the BBx32 or not. And especially the...
I'm Running through the grblHAL webbuilder for (primarily) selfsquaring the Y Axis on the BBx32 .. is there any documentation on the...
Perfect, thankyou!
I'll have to check tomorrow when it is connected to the controller, but when not connected the application 'starts' with the 3D view tab for me.
Works flawless, thx! I'm struggling on how to adapt it to start with that panel active; discovered it is already named tab-one, while it boots up...
Since a lot is possible to adapt the UI with the javascript macro's, like adding/removing interface buttons... would it also be possible in this...
True for jobs, not for 'when connected'; but thats fixed with $N0 Questions 2, 3 and 4 remain :)
$N0=M8 works, thanks!
A few questions; Is there a way in Openbuilds Control to run gcode commands 'on connect', 'before start job', 'after start job' ?For example,...
I'm experiencing an issue with the flattening wizzard... or rather with the tool. When the tool passes from right to left, there is zero 'bump' ,...
Carveco; grbl post. But i noticed i had a tiiiiiiiny stepover, which generated an enormous toolpath, (which ran just fine without the renderer...
