Separate names with a comma.
Some features disabled for guests. Register Today.
Hi How to disable auto start CONTROL when turn my old laptop on every time Just bought mini PC and touchscreen to use it only with only CONTROL...
Thank you again Asked github and they told me to flash through web builder I tried first 3 axis firmware on CONTROL but same Then went to web...
Tired $73=2,$73=3 With $70 =from 0 to 7 Every time error52 show up
Great thank you Please how to do it? Didn’t find it on documentation
Thanks @Peter Van Der Walt You the device that extends wifi ? My shop is not close to home Interface will cost a lot with shipping What about...
Hi I have my machine working perfectly with USB no problem But now i have to move my laptop a bit far away for CNC as my shop becomes too tight...
Abort is stop 0-10v, and enable become zero But NO relay stay same close After that send m5, no thing Need m3 then m5 to to open the NO relay
Clear, thank you Correct, just in my case i control rpm bia vfd not 0-10v if i use it it will drop to 0 without it, its not stop NO relay
Ok,Because it’s always in run mode,that’s 10v from vfd x1 is zero Its 10v only if i disconnect it from BB i don’t have physical e stop swich I...
Using NO relay works good but not responding for aport What’s if I use isolating board like this ? [ATTACH] NO relay is working ok to run and...
Analog is correct m3 s24k =24k rpm S12k = 11800rpm Just want to make sure nothing hurts BB and spindle,use use isolate board , or i stick with...
F007 minimum frequency default 0.5 Change it to 10hz And added second gnd from bb to vfd that works to stop spindle by m5 But vfd still in run...
Yes that measurement without wire connecting X1 is for run not analog X1=10v when stop mode, 0.03v when run mode VI1 analog is zero, just takes...
@Peter Van Der Walt Could please see the above reply And do you have diagram for BB32?
Just discovered X1 has 10volt [ATTACH] I think it shouldn’t has this, not sure if it make damage for BB ? Something like this opto will helps??...
Thank you, selected lead1515 then fixed Now need change step/mm and invert axis that easy Notice that happened again when enabled homing in...
Hello When tried to home machine only Z axis move down (should be up ) few mm then stop and show me error checked troubleshooting and see z,y...
Yes im sure you are right Just waiting to finish the very slow discussion with the Chinese thank you so much
What I understood is 0-10v to control control hz And x1&2&3&4&5&6 to run/stop spindle 0-10v works fine Run command whenever it has gnd and...
I set minimum operation to 80hz to to avoid very low speed 0-10v analog is work correctly But run commands is the problem
