Separate names with a comma.
Some features disabled for guests. Register Today.
Okay when I use these numbers: I get pretty much 180 degrees. Is this okay to continuously run if my pulse width is 900-2100μs for the servo?...
Pulse width is 900-2100μs, so then it would be 4.5 and 10.5 for the range I think? When I do this maybe I get 100 degrees, but also if that is...
Thanks, this is interesting! Footnote 13 says: 13 Set $33=50 (PWM frequency), $34=5, $35=5 and $36=10 to generate a "standard" PWM signal: 20ms...
I have been playing around with $30 and it seems that as I raise it the range expands but is still limited (although less so) Above 1800, I get...
Okay wired it with additional PSU option, plugged in with 5v and tried 6v, and the servo is still limited. After around 31, it stops...
It works only in a very low range (13-30) on a variety of my crappy and not so crappy servos, 9g micro servos. Couldn't be a setting issue? Would...
I am getting a little bit of action in the low part of the range (0-20) but otherwise it is acting strange. I'll keep playing.
Just wanted to check in again. I haven't got it to work yet. Steppers working great though
$0=10.0 ; Step pulse time, microseconds $1=255 ; Step idle delay, milliseconds $2=0 ; Step pulse invert, mask $3=1 ; Step direction...
Here they are:
I am just testing the new blackbox and can't get it to activate the servo. I have tried a few different servos. I hear a faint click but get no...
I am in Europe and have actually found lots of different companies that stock OpenBuilds product including the things you mention. Ratrig.com in...
Oh good to know, I would actually have thought better resolution so shows what I know :) And thanks for other answers
Hi— I already asked the question about substituting 2040 for 2020 in the 1515 build and am going to try that. I have some other small options,...
Can I build an Acro 1515 and sub out the 2020 with 2040 and use the same plates? It seems like it should be no problem but just wanted to check.
This is a completely unimportant issue but my time estimate when I run a plot is generally really off, sometimes by an hour or so. Is there a way...
Also not shocking but the accuracy of my machine which I was thinking was primarily the pen holder is greatly improved with fixing that. Amazing...
Grubscrews was the answer! Thanks for thinking of this :)
I like this idea, definitely could be the problem...will check!
Just tried both of these things. 1) Doesn't seem to be overheating. The exclamation isn't lit. And I have turned the current all the way down....
