Separate names with a comma.
Some features disabled for guests. Register Today.
I have success!! Probably should have used a smaller bit. But at least it worked!! [ATTACH]
Oh Mah Gawd! That was it. The stepper was the problem. I know that it is rare for these to fail, but I think it was the bearing internally....
Pulley is solid. I cleaned all of the components, and the move freely now. Previously they were caked with saw dust. I wonder where that came...
I've checked that multiple times. I think it might be mechanical. Time to disassemble, check the bearings, and install a new M2 belt.
Yeah, X is still messed up. Its missing steps for sure. I did a Home All, and then told it to go back to Work Zero. Z and Y were perfect, but X...
Got some help calibrating $100, $101, and $102 so I have better steps/mm now. Still some issues with XYZ probe, and the X-Axis is questionable....
That was very helpful! My original values were double the calculated values. I was able to use the probe to set X, Y, and Z individually and the...
I picked up a used BoB's CNC e3 a while back, and had a lot of fun with the Arduino controller board, but ultimately, I wanted to make it better...
I'm at 80 steps per mm. That was the recommendation for the BoB's CNC that I am currently trying to upgrade to the BlackBox. So far, it is...
I'm new to this, so this reply may not have anything to do with your code update... Using the probe to set Y0 appears to work, but, when I say go...
Works for me too!
Yep. And updated the firmware on the Blackbox X32 and the Interface.
Just for a bit of clarification, because all that swap Y with Z thing gets a but confusing... I made it easier. When the Y motor is in the Y...
I just installed the new BlackBox X32 on my rig, and I can get everything to move except for the Y2 motor. The motor and wiring are fine. I...