Separate names with a comma.
Some features disabled for guests. Register Today.
Worked perfectly. The key was to double-click the CAMPost Folder. Thanks.
Thanks Peter. Will try this.
Hi Peter, I followed the directions above, but hit a dead end when I tried to upload the OpenBuilds postprocessor .cps file to Fusion Assets. In...
Thanks, David This sounds like a good reason for me to switch to the OpenBuilds postprocessor. I looked at Fusion and see that the postprocessor...
Thanks Peter, Maybe I should consider using the OpenBuilds Post Processor instead of the one that comes with Fusion. Is there a Thread on the...
I use Fusion, which always adds Gcode at the end of the final operation that sends the Holder to the Home position. I want to eliminate that...
Tightening the lead screw collars and motor mounts made a difference. Everything is where I need it to be. Thanks!
I hadn't checked the collars but just tightened them. Also tightened the motor mounts which had been a little loose. I had already tightened the...
Thanks for you reply, Gary. I'm using a brand new router bit. I'll look up the spindle. Just looking at the spindle running free, I can't tell...
I was cutting some Delrin parts on my Millright Carve King using Open Builds UGS software today and accidentally ran the bit into an aluminum...
Thanks Alex. I found this post that gives similar advice: But, when we see this issue, its usually mechanical, and then usually: setscrews...
I use Builds Controller on a Mac to control my Millright Carve King. It has worked perfectly until today. After cutting 60 parts perfectly, I...
