Separate names with a comma.
Some features disabled for guests. Register Today.
To add some other things to check, as I had this issue too, I eventually noticed that when I touched the wiring coupler on the X stepper motor, it...
It appears that I busted a bearing on the ER11, see attached picture. I don't see in the store where I can purchase new bearings or not. The...
Disregard, you can adjust it only while it's running
I never paid too much attention to the F and S display on the interface, is there a way to adjust those while the job is being run? I'd like to...
Got it to work Rewired the switch and the message went away. Activated switched and jogging paused. Deactivated switch and cleared the alarm,...
Thank you!
I only removed the door switch to figure out where the issue was/is. After reflashing i will make sure the door trigger is wired correctly too....
I'll reflash back to a version without the door code in it, jog it around and then reflash back again and report back here, thank you.
Hi, yes, the switch has been removed from the controller and it was then reflashed. If that's still an issue I can only theorize that some memory...
Hi all, I've just reflashed the firmware according to the instructions and immediately after the reset, I am greeted with the MSG:Check Door in...
I have a fully loaded 1515 with mdf spoiler boards, mdf on the below shelf and the modular table. I don't know of any way I could weigh it for...
Just curious if you got this working and if so, what has your experience been in the last year with this here?
Does anyone here have the specifications of what the did to strengthen the table down further? I'm thinking of getting 4 20x20x1000 v rails and...
I am unable to manually move the Y1 gantry plate. Steps below of what lead me here: Noticed a screw that became loose and fell off the Y1 gantry...
It appears I should be able to turn the motors by hand and not by a tool. Next issue to resolve
Old thread, but I'm curious if anyone knows exactly which screws to loosen so I could perform the same action that the video shows? I'm racking my...
I suspect my terminology of each piece is not accurate lol, still learning everything here. After watching the video a few times, I loosened the...
Can the screw be turned by hand easily (same on both sides)? Unknown which screw exactly. The flexible coupling? Wheels too tight? Possibly Anti...
I've noticed that the Y stepper motor has been stalling, approximately 2-3 times in the last couple of weeks or so. This occurs, generally, hours...
What was the GRBL setting? I've had intermittent issues, though I suspect they may not be related to yours. Thank you!
