Separate names with a comma.
Some features disabled for guests. Register Today.
Good morning, The knob to adjust the power of the driver turns crazy on the Z axis is normal? on the others there is a rotation stopper but Z...
hello to you and thank you for your answer when I did my wiring I paid great attention to this problem during assembly and I did not take into...
I did the test and I receive 9V that I enter the command M3 S1000 or M3 S24000 it does not change anything however I have entered the values $30 =...
yes VFD PD04 ? or PD 07 ?
Good morning, small problem when I stop the spindle in openbuild control, my spindle continues to idle 200/300 rpm, do you have an idea? Thank you
problem solved !!! just by stripping my cable I slightly cut the sheath of a cable had to bend the cable to see the notch but a bit of insulating...
problem solved!!! just by stripping my cable I slightly cut the sheath of a cable had to bend the cable to see the notch but a bit of insulating...
I tested everything in the following way multimeter on the pin body and on the other side on each gnd 'sensor and nema but nothing the test was...
from what I see this problem comes up often why don't you make a video on the subject see things have understood them better and save you time...
Good morning, So if I understood correctly the ground of the pin does not connect to the ground of the VFD but directly to the ground of the...
what more can i do?
I contacted RatRig to see with them for the sensor change ;-) I am openbuild full equip so it would be nice to have the same brand sensors... so...
it is currently on 7 if I put it on 0 it no longer works
it displays all the temp triggered and when it detects an axis it goes off
for the Z axis it is impossible for the axis to move once it has been detected the alarm still rings even when I disconnect the wires, I have to...
here you see the X axis everything works as expected except for the fact that I receive another alarm when I want to bring the axis back, but...
no since I modified what you explained to me the sensors work on X and Y the sensors are triggered and when I move the axes I still have an alarm...
just remove the plug from the VFD
yes no problem let's work then ;-) tell me what to do.
yes if I unplug the sensor then it resumes, and therefore time for the sensor to detect the axis I no longer know how to move it so I would also...
