Separate names with a comma.
Some features disabled for guests. Register Today.
I was calibrating my Z steps using the wizard and after saving all I get is an error about baud rate. I have shut the machine down, closed OB...
Thank you, I will give those tips a try and I have a spare servo tester just encase.
Thank you David, That is exactly what I need. Not sure I will use the $32 = 1 setting as my cutter is neither laser or router, its more of a...
No fault light but the stepper is getting hot and I have the current all the way down, I guess BlackBox doesn't like Creality steppers. Who makes...
I have installed OpenBuildsFusion360PostGrbl.cps per the instructions and Fusion now produces a .gcode file that OpenBuilds Control will load and...
Sorry, I thought the last was an upload. After a bunch of searches it looks like I might be able to just use LightBurn with a new machine preset,...
Thank you, I now have servo movement as expected. Next issue is smoothing circles/curves into something closer to the input geometry. [ATTACH]...
Thank you, I have followed the blackbox-32: connect-rc-servo and the servo responds to pen up/down buttons as well as tool on/off buttons, I can...
I created a simple test drawing and converted it to a GCODE file in the OpenBuilds CAM, loaded the file in OpenBuilds Control and ran the program....
I have followed the instructions in 3.3.6 BlackBox X32 RC servo but the values for servo up and down are not being stored. After completing the...
Some bonehead swapped axis, all good now, thank you for the assistance.
I just assembled a new machine and it does not stop either axis when the limit switches are contacted during homing. Manually tripping the...
I am expanding my shop and will now have 2 Acro based machines that I want to run from a single install of OpenBuilds Control and Lightburn. One...
Thank you. I figured I screwed my self by adjusting the PWM settings, even more so as I do not have a backup of the original settings. I will try...
Yes ground is shared via a Y cable to the servo, power pin from Black box has been removed so all it provides is ground and signal
I purchased an OpenBuilds Acro 510 a couple of years ago and installed a Creality Falcon10 diode laser. All was working well until I decided to...
Looking good so far. I am working on the same idea but using a brushless motor and speed controller to power the needle. Would love to see more...
The Lightburn Start/End pause works as advertised BUT, it disables using the laser while framing which I find to be a very handy feature. Will...
There is an option in the cut settings editor Advanced tab for Start and End pause time the article I found says you must enable Cut Through to...
Thank you, I will look in Lightburn and see if that is an option and will make a note of the G4 P20 just incase.
